Outputs (17)

Tribological and Anticorrosion Performance of Electroplated Zinc Based Nanocomposite Coatings (2020)
Journal Article
Klekotka, M., Zielińska, K., Stankiewicz, A., & Kuciej, M. (2020). Tribological and Anticorrosion Performance of Electroplated Zinc Based Nanocomposite Coatings. Coatings, 10(6), Article 594. https://doi.org/10.3390/coatings10060594

This paper presents the results of corrosion and tribological analysis of pure and nanocomposite zinc coatings. Coatings were electroplated using commercially available products—zinc acidic bath and a nanoparticle carrying plating additive. Electroch... Read More about Tribological and Anticorrosion Performance of Electroplated Zinc Based Nanocomposite Coatings.

Monitoring of the Critical Meniscus of Very Low Liquid Volumes Using an Optical Fiber Sensor (2020)
Journal Article
Binetti, L., Del Villar, I., Prabuddha Dissanayake, K., Stankiewicz, A., Sun, T., Grattan, K. T. V., & Alwis, L. S. M. (2020). Monitoring of the Critical Meniscus of Very Low Liquid Volumes Using an Optical Fiber Sensor. IEEE Sensors Journal, 20(20), 1223

A novel sensing system based on single mode optical fiber in reflective configuration has been developed to measure the critical meniscus height (CMH) of low volumes of liquids, which is then used to calculate the contact angle. The sensing system ha... Read More about Monitoring of the Critical Meniscus of Very Low Liquid Volumes Using an Optical Fiber Sensor.

Electrodeposition and characterisation of Ni/gelatin microgels coatings (2020)
Journal Article
Gibb, A., Vorobjovs, A., Jagoda, Z., Winiarski, J., & Stankiewicz, A. (2020). Electrodeposition and characterisation of Ni/gelatin microgels coatings. Transactions of the Institute of Metal Finishing, 98(1), 15-20. https://doi.org/10.1080/00202967.2020.16

This work focuses on implementing microgels for carrying self-healing substances in protective coatings. Ni/gelatin microgels coatings were manufactured using electroplating techniques. Microscopic analysis was carried out to establish the presence o... Read More about Electrodeposition and characterisation of Ni/gelatin microgels coatings.

Surface functionalisation by the introduction of self-healing properties into electroless Ni-P coatings (2018)
Journal Article
Stankiewicz, A., Kefallinou, Z., Mordarski, G., Jagoda, Z., & Spencer, B. (2019). Surface functionalisation by the introduction of self-healing properties into electroless Ni-P coatings. Electrochimica Acta, 297, 427-434. https://doi.org/10.1016/j.electac

Ni-P∖alginate microgels coatings, as potential metallic protective coatings with self-healing properties, were deposited by the electroless method. The alginate microgels contained nickel chloride and sodium hypophosphite. It was proven that the redu... Read More about Surface functionalisation by the introduction of self-healing properties into electroless Ni-P coatings.

Development of self-healing coatings for corrosion protection on metallic structures (2016)
Journal Article
Stankiewicz, A., & Barker, M. B. (2016). Development of self-healing coatings for corrosion protection on metallic structures. Smart Materials and Structures, 25(8), 084013. https://doi.org/10.1088/0964-1726/25/8/084013

Inspired by biological systems, artificial self-healing materials are designed for repairing local damage caused by external factors. The rapidly expanding field of self-healing systems contains, among others, materials with well-defined surface prop... Read More about Development of self-healing coatings for corrosion protection on metallic structures.

Gelatin microgels as a potential corrosion inhibitor carriers for self-healing coatings: Preparation and codeposition: Gelatin microgels as carriers for self-healing coatings (2015)
Journal Article
Stankiewicz, A., Jagoda, Z., Zielińska, K., & Szczygieł, I. (2015). Gelatin microgels as a potential corrosion inhibitor carriers for self-healing coatings: Preparation and codeposition: Gelatin microgels as carriers for self-healing coatings. Materials

Co-deposition of a coating with capsules containing a corrosion inhibitor is one of the methods to protect the material surface against corrosion. This generation of coatings can be regenerated in response to mechanical or chemical damage. The paper... Read More about Gelatin microgels as a potential corrosion inhibitor carriers for self-healing coatings: Preparation and codeposition: Gelatin microgels as carriers for self-healing coatings.

Machine Vision System for Corrosion Detection as an Additional Tool beside EIS for Evaluation of Protective Properties of Electrolessly Deposited Ni-P Coatings (2015)
Journal Article
Stankiewicz, A., Stankiewicz, M., Winiarski, J., Szczygieł, I., & Szczygieł, B. (2015). Machine Vision System for Corrosion Detection as an Additional Tool beside EIS for Evaluation of Protective Properties of Electrolessly Deposited Ni-P Coatings. Soli

The electroless deposition technique was used to obtain Ni-P coatings with various phosphorus content. Machine vision method was applied as a tool for the analysis and interpretation of the data provided by electrochemical impedance spectroscopy (EIS... Read More about Machine Vision System for Corrosion Detection as an Additional Tool beside EIS for Evaluation of Protective Properties of Electrolessly Deposited Ni-P Coatings.

Corrosion resistance evaluation of Ni-P\nano-ZrO 2 composite coatings by electrochemical impedance spectroscopy and machine vision method : Corrosion resistance evaluation by EIS and machine vision (2014)
Journal Article
Stankiewicz, A., Winiarski, J., Stankiewicz, M., Szczygieł, I., & Szczygieł, B. (2015). Corrosion resistance evaluation of Ni-P\nano-ZrO 2 composite coatings by electrochemical impedance spectroscopy and machine vision method : Corrosion resistance eval

Ni-P\nano-ZrO2 composite coatings were obtained on the AISI 304 steel substrate by the electroless method from a bath containing dodecyltrimethylammonium bromide (DTAB). This cationic surfactant prevents ZrO2 agglomeration in the bath and affects the... Read More about Corrosion resistance evaluation of Ni-P\nano-ZrO 2 composite coatings by electrochemical impedance spectroscopy and machine vision method : Corrosion resistance evaluation by EIS and machine vision.

Corrosion resistance of Ni-P\CePO 4 coatings obtained from sol solutions : Corrosion resistance of Ni-P\CePO 4 coatings (2014)
Journal Article
Winiarski, J., Gałuszka, M., & Stankiewicz, A. (2015). Corrosion resistance of Ni-P\CePO 4 coatings obtained from sol solutions : Corrosion resistance of Ni-P\CePO 4 coatings. Materials and corrosion : with International Corrosion abstracts = Werkstoffe und Korrosion : Organ der Arbeitsgemeinschaft Korrosion und der Dechema-Beratungsstelle für Werkstoff-Fragen, 66(6), 557-561. https://doi.org/10.1002/maco.201307570

Combined sol–gel and electroless plating techniques were used to obtain nickel-matrix composite coatings. Scanning electron microscopy (SEM) was used to examine the surface morphology. Energy dispersive spectroscopy (EDS) was employed to analyze the... Read More about Corrosion resistance of Ni-P\CePO 4 coatings obtained from sol solutions : Corrosion resistance of Ni-P\CePO 4 coatings.

Summary of Existing Models of the Ni-P Coating Electroless Deposition Process: MODELS OF THE NI-P COATING ELECTROLESS DEPOSITION PROCESS (2013)
Journal Article
Stankiewicz, A., Szczygieł, I., & Szczygieł, B. (2013). Summary of Existing Models of the Ni-P Coating Electroless Deposition Process: MODELS OF THE NI-P COATING ELECTROLESS DEPOSITION PROCESS. International Journal of Chemical Kinetics, 45(11), 755-762. https://doi.org/10.1002/kin.20810

Electroless nickel-phosphorous plating is a technique often employed in preparation of protective, decorative, and functional coatings. Several feasible mechanisms are discussed in the literature. The influence of process parameters on metal coating... Read More about Summary of Existing Models of the Ni-P Coating Electroless Deposition Process: MODELS OF THE NI-P COATING ELECTROLESS DEPOSITION PROCESS.